Two coaxial cables with gold-colored RF connectors and braided outer jackets.

RF Coaxial Cable Assemblies: VSWR, Insertion Loss, and Manufacturing Considerations

Termination geometry, cable deformation, and assembly length can affect RF performance even when a coaxial cable assembly meets its mechanical and electrical continuity requirements.

Connector Transitions and VSWR

Impedance discontinuities at connector transitions can affect VSWR, particularly at higher frequencies.

Manufacturing variables include center conductor positioning, shield termination, connector-to-cable compatibility, and preservation of cable geometry near the connector interface.

Even with qualified components, the finished assembly’s VSWR depends on the completed termination.

Cable Construction and Insertion Loss

Insertion loss depends on cable construction, length, frequency, and connector interfaces.

Semi-rigid, flexible, and LMR coaxial cables differ in their response to bending and mechanical deformation. Changes in cable geometry can affect RF performance, particularly when bend limits are exceeded or the assembly experiences repeated handling.

Measurements made before installation may not represent performance after the cable is routed into a constrained configuration.

Defining Representative Test Conditions

Acceptable VSWR does not establish acceptable insertion loss, or vice versa.

Production requirements should specify the relevant frequency range, performance limits, and measurement conditions.

Where installed routing or repeated flexing could affect performance, acceptance requirements should distinguish initial assembly measurements from any additional verification required under those conditions.

Custom RF Coaxial Cable Assemblies at TMC

TMC–The Mate Company manufactures semi-rigid, flexible, and LMR coaxial cable assemblies for commercial, military, and aerospace applications, with VSWR and insertion-loss testing.

Sourcing custom RF coaxial cable assemblies? Request a quote with your drawings, connector specifications, frequency requirements, and applicable acceptance criteria.

Similar Posts