Prototype to Production: Wire Harness Manufacturing Consistency
A wire harness can meet prototype requirements yet encounter production inconsistencies when tooling, manufacturing methods, or facilities change. Maintaining the approved design is only part of the challenge; the manufacturing processes used to produce it must also deliver consistent results.
Tooling and Process Differences
Production transfers may introduce different crimp equipment, applicators, wire-preparation methods, fixtures, or inspection setups.
Even when the assembly drawing remains unchanged, these differences can affect termination quality, dimensional consistency, and repeatability.
Key considerations include:
- Compatibility of tooling and applicators with specified terminals and wire sizes.
- Applicable crimp-height, pull-force, and other process-verification requirements.
- Fixture-dependent routing, branch lengths, and dimensional tolerances.
- Consistency of inspection methods and acceptance criteria.
Meeting finished-product acceptance criteria does not eliminate the need for appropriate manufacturing process controls.
Component Sourcing and Material Equivalence
A receiving facility may use different distributors, suppliers, or locally available materials.
Approved manufacturer lists, component specifications, and substitution restrictions must remain applicable across production locations.
Parts that appear interchangeable may differ in plating, insulation, dimensional characteristics, or qualification status. Any proposed substitution should be evaluated against the approved design and contractual requirements before use.
Transferring Production Between Facilities
A production transfer requires more than providing the receiving facility with the latest drawings and bill of materials.
Tooling configurations, assembly instructions, process parameters, and inspection methods may also need to be transferred or independently established.
The relevant question is whether the receiving facility can consistently produce assemblies that meet the approved manufacturing and acceptance requirements.
Where required, customer approvals should be obtained before transferring production.
First Article Inspection After Manufacturing Changes
For aerospace programs subject to AS9102, changes in manufacturing location, tooling, processes, or inspection methods can trigger additional first article inspection requirements, even without a drawing revision.
Depending on the change and applicable requirements, a full or partial first article inspection may be necessary.
The need for renewed verification should be evaluated before the transferred process is released for production.
Custom Wire Harness Manufacturing at TMC
TMC–The Mate Company manufactures custom cable assemblies and wire harnesses for OEM, commercial, and industrial applications.
TMC offers prototype and small-run manufacturing in the United States, with options for higher-volume production in Asia.
Explore TMC’s commercial cable assembly manufacturing capabilities.
Planning a transition from prototype to production? Request a quote from TMC with your drawings, specifications, anticipated quantities, and delivery requirements.
